EPSON Stylus Photo R200/R210
2.3.12
Printer Mechanism/Housing (lower)
removal
o
External View
C.B.S 3x6 (5-7kgf•cm)
1
2
3
C.B.P 3x8 (5-7kgf•cm)
Paper Guide, CDR
4
Screw, Frame, Main (6-8kgf•cm)
Combination
Lever, Change
Gear, 27.2, 19.2
Wire Band
Figure 2-29. "Printer Mechanism"/"Housing, Lower" removal (1)
DISASSEMBLY AND ASSEMBLY
C.B.S 3x6 (6-8kgf•cm)
C.B.P 3x10 (6-8kgfcm)
1
2
C.B.P 3x10 (6-8kgf•cm)
3
5
Hook
(Under the tube)
Disassembly
Hooks
Handling Position
Figure 2-30. "Printer Mechanism"/"Housing, Lower" removal (2)
o
Parts/Units which should be removed before removing "Printer
Mechanism"/Housing (lower)
Paper Support Assy./Housing (left/right)/Housing (frame)/ASF Unit/Main Board/
Holder, Shaft Unit
o
Disassembly Procedure
1.
Move "Carriage Unit" to the centre of the printer.
2.
Remove the screws (x3) for securing "Paper Guide, CDR".
3.
Remove the screws (x5) for securing "Printer Mechanism".
4.
Take off the acetate tape and release the connector of "Star Wheel/CDR
Sensor".
5.
Cut off the wire band and release the connector cable.
6.
Release the hooks (x4) for securing "Printer Mechanism". Then, hold the both
right and left upper edges of "Frame, Main" and remove "Printer Mechanism"
to upward.
Revision A
2 ± 1mm
Acetate Tape
Hook
57