Lower Housing/Printer Mechanism Removal - Epson Stylus C82 Service Manual

EPSON Stylus C82
6. While avoiding 2 hooks, follow order shown below to remove Printhead from
Carriage Unit.
Hook
Printhead
Figure 4-10. Printhead Removal 4
7. Remove 2 FFCs from the Printhead.
Printhead
Figure 4-11. Printhead Removal 5
DISASSEMBLY AND ASSEMBLY
Hook
2
1
Sponge
FFCs
When the FFC has been replaced, be sure to attach sponge as
shown in lower left diagram. Because double-sided tape is attached
to FFC service parts, simply installing sponge is sufficient.
When removing or replacing the Printhead, the adjustments are
necessary. Refer to "Chapter 5 Adjustment" for the adjustment
procedure.

4.2.1.4 Lower Housing/Printer Mechanism Removal

1. Remove Upper Housing. (See Section 4.2.1.1)
2. Remove 4 screws (C.B.P 4x12: 3, C.B.S 3x8: 1) holding Printer Mechanism.
C.B.P 4x12 (6±1kgf.cm) x3
Lower Housing
Figure 4-12. Lower Housing/Printer Mechanism Removal 1
Disassembly
Printer Mechanism
C.B.S 3x8 (6±1kgf.cm)
Revision A
29