Output Power; Beacon Interval; Rts Threshold - peplink balance ONE User Manual

USER MANUAL
Peplink Balance Series
This drop-down menu determines the power at which the AP under this profile will
broadcast. When fixed settings are selected, the AP will broadcast at the specified power
level, regardless of context. When Dynamic settings are selected, the AP will adjust its
power level based on its surrounding APs in order to maximize performance.
A

Output Power

The Dynamic: Auto setting will set the AP to do this automatically. Otherwise, the
Dynamic: Manual setting will set the AP to dynamically adjust only of instructed to do
so. If you have set Dynamic:Manual, you can go to AP>Toolbox>Auto Power Adj. to
give your AP further instructions.
These buttons determine the time period at which the AP under this profile will be
activated. Clicking the Custom Schedule option will open the following diagram:
Operating
A
Schedule
Click the desired time periods to toggle the activation state of APs under this profile.
Max number of
This field determines the maximum clients that can be connected to APs under this
A
Clients
profile.
Client Signal
This field determines that maximum signal strength each individual client will receive.
Strength
The measurment unit is megawatts.
A
Threshold
This drop-down menu provides the option to send beacons in different transmit bit rates.
A
Beacon Rate
The bit rates are 1Mbps, 2Mbps, 5.5Mbps, 6Mbps, and 11Mbps.
This drop-down menu provides the option to set the time between each beacon send.
A

Beacon Interval

Available options are 100ms, 250ms, and 500ms.
This field provides the option to set the frequency for beacon to include delivery traffic
A
DTIM
indication messages (DTIM). The interval unit is measured in milliseconds.
This field provides the option to set the minimum packet size for the unit to send an RTS
A

RTS Threshold

using the RTS/CTS handshake. Setting 0 disables this feature.
This field provides the option to modify the unit wait time before it transmits. The default
Slot Time A
value is 9μs.
This field provides the option to set the wait time to receive acknowledgement packet
ACK Timeout A
before doing retransmission. The default value is 48μs.
Frame
With this feature enabled, throughput will be increased by sending two or more data
A
Aggregation
frames in a single transmission.
Frame Length
This field is only available when Frame Aggregation is enabled. It specifies the frame
http://www.peplink.com -197 / 261 - Copyright © 2015 Peplink