Connection Type - peplink balance ONE User Manual

USER MANUAL
Peplink Balance Series
12.2.5 Mobile Internet Connection
The Mobile Internet Connection method is suitable for USB modem mobile
connections, such as 3G, WiMAX, LTE, EVDO, EDGE, and GPRS. Currently, it only
applies to connections made via the Balance's USB mobile WAN port, except in the
case of the Balance units that include a built-in 4G LTE modem. For a list of supported
modems, please refer to Peplink Modem Support page at
http://www.peplink.com/modem.
WAN
12.2.5.1
Connection
12.2.5.2
Name
Enable
Click the box to enable the connection.
This setting specifies the utilization of the WAN connection. Always-on results in the
WAN connection being used whenever it is available. If Backup is selected, the WAN

Connection Type

connection is treated as a backup connection and is used only in the absence of an
available always-on WAN. The default and recommended connection type is Always-
on.
This option allows you to choose whether to remain connected or disconnect when this
WAN connection is no longer in the highest priority and has entered the standby state.
Standby State
When Remain connected is chosen and this WAN connection is made active, the WAN
connection will be immediately available for use.
With this option enabled, an idle connection will be disconnected after a specified period
Idle Disconnect
of time. This time value specified is global and will affect all WAN profiles. The mobile
connection will re-establish on demand.
Reply to ICMP
If this field is disabled, the WAN connection will not respond to ICMP ping requests. By
Ping
default, this setting is enabled.
http://www.peplink.com
Mobile Internet Connection Settings
Enter a name for this WAN connection.
-101 / 261 - Copyright © 2015 Peplink