Front Panel - peplink balance ONE User Manual

USER MANUAL
Peplink Balance Series
Password

Front Panel

To require a 4-digit passcode to access front panel controls, check this box and then select
Passcode
the code from the drop-down menus.
This field specifies the number of hours and minutes that a web session can remain idle
Web Session
before the Balance terminates its access to the web admin interface. By default, it is set to 4
Timeout
hours.
With this box is checked, the web admin will authenticate using an external RADIUS server.
Authenticated users are treated as either "admin" with full read-write permission or "user"
Authentication
with read-only access. Local admin and user accounts will be disabled. When the device is
by RADIUS
not able to communicate with the external RADIUS server, local accounts will be enabled
again for emergency access. Additional authentication options will be available once this
box is checked.
This specifies the authentication protocol used. Available options are MS-CHAP v2 and
Auth Protocol
PAP.
Auth Server
This specifies the access address and port of the external RADIUS server.
Auth Server
This field is for entering the secret key for accessing the RADIUS server.
Secret
Auth Timeout
This option specifies the time value for authentication timeout.
Accounting
This specifies the access address and port of the external accounting server.
Server
Accounting
This field is for entering the secret key for accessing the accounting server.
Server Secret
Network
This option is for specifying the network connection to be used for authentication. Users can
Connection
choose from LAN, WAN, and VPN connections.
Restricted
Check this box to restrict management to administrators connected to the management
Admin Access
port.
The CLI (command line interface) can be accessed via SSH. It can also be accessed from
CLI SSH &
the serial console port on some Peplink Balance models. This field enables CLI support. For
Console
additional information regarding CLI, please refer to Section 22.5.
CLI SSH Port
This field determines the port on which clients can access CLI SSH.
CLI SSH
This menu allows you to choose between granting access to LAN and WAN clients, or to
Access
LAN clients only.
This option is for specifying the protocol(s) through which the web admin interface can be
accessed:
Security
http://www.peplink.com

HTTP

HTTPS
-207 / 261 - Copyright © 2015 Peplink