Event Logging - peplink balance ONE User Manual

USER MANUAL
Peplink Balance Series
In addition, a single port, or a range of ports, can be specified for the Source IP & Port
settings.
This specifies the destination IP address(es) and port number(s) to be matched for the
firewall rule. A single address, or a network, can be specified as the Destination IP & Port
setting, as indicated with the following screenshots:
Destination IP
& Port
In addition, a single port, or a range of ports, can be specified for the Destination IP & Port
settings.
This setting specifies the action to be taken by the router upon encountering traffic that
matches the both of the following:
Action
With the value of Allow for the Action setting, the matching traffic passes through the
router (to be routed to the destination). If the value of the Action setting is set to Deny, the
matching traffic does not pass through the router (and is discarded).
This setting specifies whether or not to log matched firewall events. The logged messages
are shown on the page Status>Event Log. A sample message is as follows:
Aug 13 23:47:44 Denied CONN=Ethernet WAN SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80

Event Logging

Click Save to store your changes. To create an additional firewall rule, click Add Rule
and repeat the above steps.
http://www.peplink.com

Source IP & port

Destination IP & port

CONN: The connection where the log entry refers to

SRC: Source IP address

DST: Destination IP address

LEN: Packet length

PROTO: Protocol

SPT: Source port

DPT: Destination port
-173 / 261 - Copyright © 2015 Peplink