Throttle Cable - Can-Am DS 250 Operator's Manual

vmo2006-014-039_a
1. Gearbox drain plug
2. Gearbox fill plug
NOTE: To completely drain the gear-
box, place a jack under the left footpeg
and tilt the vehicle toward the right
side.
When the gearbox
install and
plug at
(80 lbf•in ± 8 lbf•in)
the vehicle on the ground.
Refill gearbox,
(27 U.S. oz) of XPS chaincase oil
(P/N 413 801 900) or an equivalent.
NOTE: Gearbox oil quantity is also
written on the gearbox cover.
NOTICE
Do not use other unrec-
ommended types of oil when servic-
ing. Do not mix with other types of
oil.
Reinstall and
plug to
(29 lbf•ft ± 3 lbf•ft).

Throttle Cable

Throttle Cable Lubrication
The throttle cable must be lubricated
with silicone cable lubricant (P/N 293
600 041) or an equivalent.
is empty,
torque the
9 N•m ± 0.9 N•m
and replace
using 800 ml
torque oil
39 N•m ± 3.9 N•m
Always use a silicone-based lu-
bricant. Using another lubricant
(like water-based lubricant) could
cause the throttle lever/cable stick-
ing or stiffness.
Open the throttle lever housing.
drain
vmo2006-014-051_a
1. Remove screws
Slide the rubber protector to expose
the cable adjuster.
Unscrew the lock nut of the cable ad-
juster then screw in the adjuster to
release the cable tension.
fill
vmo2006-014-051_b
1. Rubber protector
2. Cable adjuster
_______________
MAINTENANCE PROCEDURES
WARNING
87