Can-Am DS 250 Operator's Manual page 82

MAINTENANCE PROCEDURES
vmo2006-014-019_a
RH SIDE OF ENGINE
With vehicle on a level surface and en-
gine cold, not running, check the oil
level as follows:
1. Unscrew dipstick then remove it
and wipe clean.
2. Reinstall dipstick (do not screw it
in).
3. Remove and check oil level. It
should be near or equal to the up-
per mark.
vmo2006-014-020_a
1. Full
2. Add
3. Operating range
To add oil, remove dipstick.
Place a funnel into the dipstick tube to
avoid spillage.
Add a small amount of recommended
oil and recheck oil level.
Repeat the operation until oil level
reaches the dipstick's full mark. Do
not overfill.
______________
80
Properly tighten dipstick.
Engine Oil Change and Oil Strainer
Cleaning
Oil change should be done with a warm
engine.
CAUTION The engine oil can
be very hot. In order to avoid poten-
tial burns, do not remove the engine
drain plug or the oil strainer cover if
the engine is hot. Wait until engine
oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the drain plug area.
Place a drain pan under the engine
drain plug area.
Unscrew drain plug.
vmo2006-014-035_a
LH SIDE UNDERNEATH CVT COVER
1. Oil drain plug
Unscrew the oil strainer cover.
Allow enough time for oil to flow out of
oil strainer hole.