Throttle Cable - Can-Am DS 450 Series Operator's Manual

vmo2008-011-085_b
1. Screwdriver
2. Clutch adjustment wrench
To confirm proper adjustment, gen-
tly push on adjustment screw using a
screwdriver. A small axial play of ap-
proximately 0.5 mm (.02 in) should be
felt. If not, perform adjustment again.
vmo2010-012-003_a
1. Adjustment screw
A. 0.5 mm (.02 in)
NOTICE
A premature clutch disk
wear may occur if adjustment is too
tight.
Reinstall access plugs.
NOTICE
Do not overtighten.
vmo2010-012-001_a
1. Access plugs
2. Clutch cover
Properly adjust clutch lever. Refer to
ADJUSTMENT AT CLUTCH LEVER
above.

Throttle Cable

Throttle Cable Lubrication
The throttle cable must be lubricated
with CABLE LUBRICANT (P/N 293 600
041) or an equivalent.
Always use a silicone-based lu-
bricant. Using another lubricant
(like water-based lubricant) could
cause the throttle lever/cable to
become sticky or stiff.
Remove the throttle lever housing
cover.
______________
MAINTENANCE PROCEDURES
WARNING
103