iPF8400S
Paper to Prepare
When Using Rolls
An unused roll at least 254.0 mm (10.00 in) wide
When Using Sheets
Two sheets of unused paper of at least A4/Letter size
Perform adjustment as follows.
1
Load the paper.
Attaching the Roll Holder to Rolls
•
Loading Rolls in the Printer
•
Loading Sheets in the Printer
•
•
Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be completed
correctly unless the loaded paper matches the settings.
Important
2
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Settings/Adj. tab (
•
If the Tab Selection screen is not displayed, press the Menu button.
Note
3
Press the OK button.
The Set./Adj. Menu is displayed.
4
Press ▲ or ▼ to select Adjust Printer, and then press the OK button.
5
Press ▲ or ▼ to select Feed Priority, and then press the OK button.
6
Press ▲ or ▼ to select Adj. Quality, and then press the OK button.
7
Press ▲ or ▼ to select Manual, and then press the OK button.
Test pattern A is printed for manual adjustment.
•
When printing on sheets, follow the instructions on the Display Screen and remove the sheet.
Note
8
Examine test pattern A for adjustment. Determine the
pattern in which banding is least noticeable.
•
If banding seems least noticeable in two patterns but you cannot decide which one is better, choose an inter-
mediate value.
Note
For example, choose 11 if you cannot decide whether pattern 10 or 12 is better.
User's Guide
P.469
➔
P.471
➔
P.492
➔
).
Manual Banding Adjustment
721