Installation Procedures; Installing Lamp - Vari Lite VL2402 User Manual

VARI LITE® - VL2402™ W

Installation Procedures

Installing Lamp

In the event the lamp was packed separately during shipment, it will be necessary to
install in the luminaire before use.
WARNING: Ensure that power is removed from luminaire when installing lamp.
CAUTION: Wear cotton gloves or other covering while installing lamp. Touching
lamp glass with bare fingers will leave oil and may cause the lamp to explode or
reduce lamp life. If touched, use alcohol and cotton cloth to thoroughly clean glass
portion of lamp.
To install lamp:
1. Ensure power is removed from luminaire.
2. Remove lamp from shipping box.
3. At backcap, using slotted screwdriver
4. Slide backcap away from head assembly
5. Install lamp by pressing into socket. Ensure lamp is fully seated in socket
6. Align guide rods in guide holes and slide backcap into head assembly. Re-
Note: After installing a new lamp, it is necessary to adjust the beam for optimum per-
formance. This procedure is covered in
16
L
ASH UMINAIRE
(or fingers) turn captive knob until
loose.
(it will remain attached by tether and
lamp wires).
CAUTION:
Ensure lamp is seated
straight in socket before
re-installing backcap.
and parallel to guide rods. (Lamp can be damaged when inserted through
reflector if not parallel to guide rods.)
tighten captive knob.
17-Sept-01
U ' M
SER S ANUAL
Lamp
"Powering Up" on page
Captive Knob
Backcap Assembly
Guide Rod
21.
02. 9671.0 001 C