Vari Lite VL2402 User Manual page 112

VARI LITE® - VL2402™ W
Note: In some cases it is easier to slide bulkhead partially out of head assembly to
access color filters. To do this, use #2 Phillips screwdriver to turn captive screw one-
quarter turn and slide bulkhead upward. Disconnect motor connections as necessary.
3. Rotate wheel until required color filter is accessible at finger access cutout.
CAUTION: Do not touch color filters with bare fingers. Wear cotton gloves or other
covering while replacing. Clean with glass cleaner and soft cloth if touched.
4. Using fingers, pull color filter out of
5. Noting proper orientation of carrier
6. Re-install bulkhead (if applicable)
94
L U
ASH UMINAIRE
See Figure A-3.
Finger Access
Cutout
Color Wheel
Figure A-3: Filter Replacement
wheel.
slot, insert new color filter into
position and push fully into place.
See Figure A-4.
and re-install removable cover.
17-Sept-01
' M
SER S ANUAL
Color
Filter Wheel
Figure A-4: Filter Installation
Color Filter
Carrier Slot
02. 9671.0 001 C