Control Channel Functions - Vari Lite VL2402 User Manual

Control Channel Functions

The following control actions must be accomplished with zero time transition or with
timing disabled. Discrete values must be used and not manual controls such as faders
or encoders.
Channel
Function
Display On
Snap On
Snap Off
Luminaire Reset
Lamp Off
Lamp On
To use control channel functions:
1. Select an action to be sent.
2. Set control channel value for desired action (for example, 84 for reset). Hold
Note: A numerical keypad is required for sending values. An encoder or fader does
not allow for a quick value change, which is required to affect the control functions.
3. Set control channel value to zero. (This must occur without any scaling
Note: The Snap control channel function takes place immediately, and does not
require the control value be set to zero after three seconds. For more information on
Snap functionality see
02.9 671.00 01 C
Control
% Value
value for 3 seconds.
values. Action will be voided if other values are detected between action
value and zero.)
"Snap Colors" on page
O
PERATION
Control Channel Value
For 3 Secs
or Greater
1 1-4
9 20-25
13 30-35
33 81 - 87
66 165 - 171
99 249 - 255
27.
17-Sept-01
: L T
UMINAIRE IMING
After
3 Secs
0
N/A
N/A
0
0
0
3
41