Table of Contents
Advertisement
Installation Procedures
Floor Mounting the Luminaire
This luminaire included in this manual are designed to sit directly in a floor installation application.
When used in this type of application, be sure to leave enough space around the luminaire to allow
proper, uninterrupted airflow for cooling and movement.
Hanging the Luminaire
The VL800 EVENTWASH Luminaire can be hung horizontally or vertically from any structure
designed to work with the type of load created Clamp and Quick lock fastener or other mounting
hardware are required. Many compatible truss hooks are available from different manufacturers for
your particular needs.
One Quick-lock fastener per luminaire is required. If mounting method does not use truss hooks,
two attachment points per luminaire, are required. Always ensure the diameter of safety cable is at
least 4 mm, which can support at least 12 times of weight of unit.
Install mounting hardware and brackets:
Step 1. Bolt each clamp to the Omega holder with
screw and lock nut through the hole in the
holder as shown in Figure 3
Various types of truss hooks can be used.
Note:
The Clamp (as shown in the example above) as
well as many other standard hooks, can be
ordered separately.
Step 2.
Faster the omega holders on the bottom of
the base by inserting quick-lock fasteners
into the holes of the base and tighten fully
clockwise.
Step 3.
Hang the fixture to the support through clamp and faster the screws, faster the safety
cable through the bottom of the base and over the support.
VARI❋LITE - VL800 EVENTWASH QUICKSTART GUIDE
2 July 2020
13
Advertisement
Table of Contents
