Table of Contents
Advertisement
VL1600 ProfiLe
2
InsTallaTIOn & seTuP
POWER AND DATA CABLING REQUIREMENTS
CONNECTING POWER
This fixture requires standard AC power distribution from 100-240 VAC, 50/60 Hz. Current required depends on
the AC supply voltage.
NOTE: The mating Neutrik® powerCON® True1 connector is supplied; however, you will need to purchase or
construct a cable appropriate for your application.
Depending on the application, the luminaire's AC input cable may require a dif-
ferent connector. If required, install a new connector meeting your requirements
using the following wire color code reference:
WIRE*
Green/yellow
Blue
Brown
* International (Harmonized) standard
WARNING: DO NOT connect to three-phase service in countries with 240V power.
For single-phase power at 240 volts RMS:
X
G
aC neutral
aC line
Y
Ground (earth)
CURRENT VERSUS VOLTAGE
taBle 1
provides the luminaire's current draw at specific voltages. Total luminaire current is calculated with the
lamp on and all motors sequencing.
WARNING! It is the responsibility of the user to ad-
equately protect supply source with a correct size and
type circuit breaker and not overload circuits.
WARNING! It is not recommended to power any
Vari-Lite luminaire from a dimmer - even in 'NONDIM'
mode. Dimmer and non-dim modules are not suitable
sources of power because their output modifies the AC
wave form. This may work for a short time, but will even-
tually result in power problems, luminaire misoperation
and/or failure and may void the luminaire's warranty.
CONNECTION
aC ground
aC neutral
aC line
CONNECTION
PIN
X
Y
G
For three-phase power at 200 volts RMS:
CONNECTION
Phase 1
Phase 2
Ground (earth)
TAbLE 1. CURRENT VS. VOLTAGE (550W SOURCE)
AC VOLTAGE AT 60HZ
100V
110V
120V
130V
200V
210V
220V
230V
240V
7
user manuaL
AC
DATA
POWER
THRU
NETWORK
INPUT
DATA IN
USB
AC
POWER
THRU
PIN
X
Y
G
TOTAL CURRENT
7.8a
7.0a
6.4a
5.9a
3.8a
3.6a
3.4a
3.3a
3.2a
w w w.Va r i - L i t e .c o m
Advertisement
Table of Contents
