Vari Lite VL2402 User Manual page 82

VARI LITE® - VL2402™ W
Display Definition
P/T Pan/Tilt
Pan Pan
PASS Test Pass
PCue Play Cue
POWR Lamp Power
PROG Programming
PSEQ Play Sequence
RCAL Recalibrate
RDef Reset Default
RHrs Reset Lamp Info
RTST Run-Test
SAVE Save
ScXX Sequence Data
Sens Sensors
SEQ Sequence Playback Sets sequence playback mode to Individual (plays cues from each luminaire) or
SNAP Snap
STAT Status/Error Display Allows scrolling through error list or displays OK if no errors.
Stor Store Cue
Strb Strobe
Strk Strike
STST Sensor Test
SWAP Swap
Test System Tests
Tilt Tilt
Time Timing Data
Ver Version
VIRT Virtuoso console
64
L U
ASH UMINAIRE
Table 4-3: Menu Function Definitions (Continued)
Accesses pan and tilt options for DMX function, system configuration, and
testing.
Specifies pan function for manual control (Man) or pan encoder for testing (Test).
Indicates that sensor test has passed.
Accesses cue list for play back of cues by number.
Accesses function to turn lamp on or off.
Currently programming the new version of software.
Plays back cue sequence. Press [Enter] to start and [Menu] to stop.
Currently executing Calibration.
Resets default system configuration values.
Resets lamp hour and lamp strike counters. For use when new lamp is installed.
Indicates that a system mechanism test is in progress.
Saving cue data.
Sequence playing cue number, where XX defines cue number.
Accesses sensor choices for diagnostic testing.
Master (all luminaires play same cue).
Enables, disables the colors (Blue, Amber, or Magenta) taking the shortest
distance from one color to the next.
Stores cue by number. Cue number stored is dependent on next cue ID in cue
list since this field is not editable.
Specifies strobe function for manual control.
Displays total number of lamp strikes.
Indicates that a system sensor test is in progress.
Swaps pan and tilt functions for special focus requirements such as moving
mirror mechanisms.
Accesses diagnostic tests for internal mechanisms.
Specifies tilt function for manual control (Man) or tilt encoder for testing (Test).
Allows manual setting of timing values for dimmer/intensity, focus, color, and
beam.
Displays current software version (in two pages).
Sets starting address for luminaire in Virtuoso systems.
17-Sept-01
' M
SER S ANUAL
Purpose
02. 9671.0 001 C