Male Termination Connector; Loopback Connector - Vari Lite VL2402 User Manual

Male Termination Connector

When transferring software versions from luminaire to
luminaire, a male XLR termination connector is required at
the "master" luminaire. To construct your own connector, you
will need the following components:
• 5-pin, male XLR connector.
• Two 1/4W 5% 120 ohm resistors.
Note: A male termination connector is available as an accessory from Vari-Lite. See
"Accessories" on page

Loopback Connector

When transferring software versions from luminaire to
luminaire, a loopback connector is required at the final
luminaire in the data link. To construct your own connector,
you will need the following components:
• 5-pin, male XLR connector.
• Two small segments of 22AWG wire.
Note: A loopback connector is available as an accessory from Vari-Lite. See
sories" on page
02.9 671.00 01 C
I : P
NSTALLATION OWER AND
101.
101.
17-Sept-01
D C R
ATA ABLING EQUIREMENTS
5
4
3
Solder resistor
across pins 2 & 3,
and 4 & 5
5
4
3
Solder wires across
pins 2 & 4 and 3 & 5
2
BACK
VIEW
1
2
BACK
VIEW
1
2
"Acces-
15