Error Messages - Vari Lite VL2402 User Manual

Error Messages

If a problem occurs during luminaire calibration, at the end of the calibration sequence
the Menu Display will cycle through any applicable error message(s), one at a time
until the end of the list is reached. To review the error messages again, it will be
necessary to access them using the Status function. (Refer to
page 85
Access Error Messages:
1. Press [Menu].
2. Press [Up] / [Down] arrows until Fixt (Fixture) appears. Press [Enter].
3. Press [Up]/ [Down] arrows to access STAT. Press [Enter]. (Display will now
Display
OK
B1M1 / MAG / NoSn
B1M1 / MAG / SAct
B1M2 / Dimm / NoSn
B1M2 / Dimm / SAct
B1M3 / CWhl / NoSn
B1M3 / CWhl / SAct
B2M1 / Blue / NoSn
B2M1 / Blue / SAct
B2M2 / Ambr / NoSn
B2M2 / Ambr / SAct
BRD1 / NO / COMM
BRD2 / NO / COMM
HEAD/ OVER/ TEMP
LAMP / STRK / FAIL
PAN / ENCR / FAIL
PAN / NO / SENS
PAN / SENS / ACTV
SRCH/FOR/BRD1
SRCH/FOR/BRD2
TILT / ENCR / FAIL
02.9 671.00 01 C
for a list of possible causes and remedies associated with the error messages.)
scroll through any error messages or display OK if no errors.)
Table 4-1: Error Messages
Message...
No Errors Found
Aux Board 1, Motor 1 / Magenta / Sensor Not Found
Aux Board 1, Motor 1 / Magenta / Sensor Always Active
Aux Board 1, Motor 2 / Dimmer / Sensor Not Found
Aux Board 1, Motor 2 / Dimmer / Sensor Always Active
Aux Board 1, Motor 3 / Color Wheel / Sensor Not Found
Aux Board 1, Motor 3 / Color Wheel / Sensor Always Active
Aux Board 2, Motor 1 / Blue / Sensor Not Found
Aux Board 2, Motor 1 / Blue / Sensor Always Active
Aux Board 2, Motor 2 / Amber / Sensor Not Found
Aux Board 2, Motor 2 / Amber / Sensor Always Active
Aux Board 1 Communication Failure
Aux Board 2 Communication Failure
Head Over Temperature
Lamp Strike Failure
Pan Encoder Failure
Pan Sensor Not Found
Pan Sensor Always Active
Attempting to communicate with Board 1
Attempting to communicate with Board 2
Tilt Encoder Failure
17-Sept-01
M S : O
ENU YSTEM PERATION
"Troubleshooting" on
4
55