Initialization Mode - Canon BJ-W3000 Service Manual

CHAPTER 5. TROUBLESHOOTING

5. Initialization mode

• Display items: Left or right arrow key
• Initialization of counter: Down arrow key + Enter key
• Reset the mode: Up arrow key
1 2 3
I N I T I A L I Z E
W - I N K :
Name of item
W-INK Initialization of waste ink counter
T-PLOT Initialization of carriage drive time
I/C EEPROM Initialization of warning history and error history
E/C EEPROM Transmitting EEPROM data on the engine controller
to the EEPROM on the image controller.
5–8
4 5 6 7
Contents
8 9 10 11
0 0 0 0 0 0
12 13 14 15
Remarks
Set the counter value to 0. (Used
when the waste ink absorber unit is
replaced.)
Set the carriage drive time value to
0.
Clear the warning history and error
history. During the initializing
process (for about 0.5 seconds), "*"
mark is indicated after the item
name.
During the rewriting process (for
about 0.5 seconds), "*" mark is
indicated after the item name.
(Used when replacing the engine
controller. Refer to "Replacing the
engine controller", P.5-12.)
16