Operation Panel - Canon BJ-W3000 Service Manual

4. Removing the front cover switch
1) Remove the right cover
2) Open the front cover.
3) Remove 4 screws [1] and take off the
right cover stay plate [2].
[2]
Figure 3-107
4) Disconnect connector [3], unlatch 2 hooks
[4] and remove the front cover switch [5].
[4]
[5]
Figure 3-108
(See page 3-7).
[1]
[1]
[3]
CHAPTER 3. MECHANICAL SYSTEM
B. Operation Panel
1. Removing the operation panel
1) Open the front cover, and holding the
green part, move the carriage to the
center.
2) Unlatch the hooks [1] at 4 positions from
the rear side of the right cover and remove
the operation panel [2].
[1]
[2]
[1]
Figure 3-109
CAUTION
Three connectors [3] on the operation
panel are connected. Be careful not to
pull on the harnesses too hard.
3–9