Canon BJ-W3000 Service Manual page 29

CHAPTER 1. GENERAL DESCRIPTION
[6] Media Setup
Used to change paper settings.
a. Roll/Cut Sheet
[Default: Previous setting preserved]
Select roll media or cut sheet.
• Roll Media
Select this to use roll media. If a cut
sheet is loaded, it will be ejected.
• Cut Sheet
Selected when cut paper is used. If roll
media is loaded, it is reverse fed and
withdrawn.
b. Media Type [Default: Plain paper]
The following media types can be se-
lected:
• Plain Paper
• Coated Paper
• Tracing Paper
• Film
c. Margin [Default: Normal]
Margin size at the media leading edge can
be selected.
• Normal
Leaves a margin of 5mm.
• Large
Leaves a margin of 15mm.
d. Copies [Default: 1]
Specify the number of copies to be
printed.
1 - 99
1–16
[7] Auto Cut
a. Cut Type
[Default: Cut]
Select the type of cut for roll media after
completion of printing.
• Cut
Cuts the roll media automatically after
completion of printing.
• Cut Line
After completion of printing, a cutting
line is printed.
• No Cut
After completion of printing, the roll
media is not cut.
b. Drying Time (only for roll media)
[Default: Off]
Sets the time for drying the ink after
completion of printing.
• Off
Paper is ejected as usual.
• Auto
Optimum drying time is automatically
selected according to the media type and
printing mode.
In the case of draft mode, the drying
time is the same as for [Off].
• 30 sec., 1 min., 2 min., 5 min.,
10 min., 20 min., 30 min., 40 min.,
50 min., 60 min.