Table of Contents
Advertisement
Entries in the Cue Sheet dialog box
In the Cue Sheet dialog box, use the following principles to enter event
attributes.
Entry method
• Press the B1 (Next) key, or hold the SHIFT key and press the B1 (Prev) key
to select the attribute that you want to set. For detailed attribute settings, use
the MULTI CONTROL knob to enter values.
• The duration and end time are linked. If you set one, the other is set
automatically.
• If the current date and time, registered events, or other items do not match
those set on the Cue Sheet, the invalid items flash and you cannot close the
dialog box using the B7 (OK) key until the invalid values are set correctly.
• The play program must be specified on the same Cue Sheet as the recorded
material program.
• The play delay must be shorter than the loop recording duration only when
the loop recording play type is set to 1 Time.
• If multiple events are set to the same port on the Cue Sheet, there must be an
interval of at least 1 minute between the end time of one event and the start
time of the next event. This applies to both recording and play.
Confirming entries in the dialog box
• To confirm entered events, press B7 (OK). The Cue Sheet dialog box closes
and the entered attributes are set.
• To cancel the entry, press B6 (Cancel). The entry is cancelled and the dialog
box returns to its previous state (before it was opened).
Possible combinations of recording types (Record) and play types
(Play)
Record
Off
Play
Off
–
1 Time
Daily
Weekly
Possible
Not possible
Note
When 1 Recording Type is set to Daily or Weekly, it is not possible to select
the Manual play trigger in 8 Play Type or set qd Play delay.
1 Time
Loop
Daily
Chapter 3 Operating Modes
Weekly
3-57 (E)
Advertisement
Table of Contents
