Sony MAV-777 Operation Manual page 60

3-6 CP Setup Mode
Category Number Name
General 0013 Enforced EE
Setup Operation
0014 Material
Numbering
0015 Step Unit
Material 1001 Display Attributes
Setup
1002 Date Format
1003 Material Monitor
Edit Setup 2001 Edit Point Entry
Method
2002 Auto Edit
Emulation
2003 Channel Selection
Mode
2004 Total Time Type
3-36 (E)
Chapter 3 Operating Modes
Settings Description
Disable Specifies whether enforced EE operation is used or not.
Enable Item 109 ENFORCED EE INTERFACE of the MAV-777 Basic
menu must be set to Enable.
Unused Smallest Specifies how 4-digit numbers are assigned as material names of
Incremental files created automatically.
Unused Smallest: Assigns the smallest currently unused number.
Incremental: Increments the largest currently used number by
1 and assigns this number. When 9999 is reached, then operates
same as Unused Smallest.
None Sets the size of jumps during STEP operation.
1 Field
1 Frame
2 Frames
5 Frames
1 Second
No.+Name+Length Sets the combination of material attributes displayed in the
No.+Name+Update material list of the Material mode screen.
No.+Name+Others Others are as follows:
P (Protect): P (Protect), no display
Q (Quality): HD
C (Category): R (Raw), E (Edited)
MM/DD/YYYY Specifies the date display format.
DD/MM/YYYY If MM/DD or DD/MM is selected, then in place of the year (YYYY)
YYYY/MM/DD the seconds and number of frames are displayed.
MM/DD
DD/MM
Auto Sets whether the type of screen displayed in the monitor display
Manual area of the Material mode screen (monitor image or stamp
picture) automatically switches according to the current operation
status.
Auto: Switches automatically.
Manual: Can be switched manually.
With Entry Sets whether IN and OUT points are entered during editing by
Alone pressing the IN or OUT buttons only, or by pressing them with the
ENTRY button.
On Makes Auto Edit emulation settings.
On with SHIFT Editing needs to be in real time when Auto Edit Emulation is used.
Off with SHIFT On: Auto Edit emulation is always used.
On with SHIFT: Auto Edit Emulation is used when the AUTO EDIT
button is pressed while holding down the SHIFT key.
Off with SHIFT: Auto Edit Emulation is used when you press the
AUTO EDIT button without holding down the SHIFT key.
Video/Audio Specifies the channel selection mode. If this setting is changed
Audio Channel during editing, it takes effect only at the next 1st Edit.
Video/Audio: If you want to select Assemble/All, Video, Audio
simultaneously for editing, select Video/Audio. With Video/Audio
selected, you can handle material in pages.
Audio Channel: Select when you want to select each audio
channel independently for editing.
Whole Program Selects the type of time displayed for the total time of the
Up to Current Page duration.
Video/Audio mode
Whole Program: Displays the duration total for the entire program.
Up to Current Page: Displays the duration total up to the current
page.
Audio Channel mode
Whole Program: Displays the length of the destination material.
Up to Current Page: Displays the duration from the beginning of
the destination material to the current OUT point (enabled OUT,
AUDIO OUT near the end) when entering the required edit points
during editing.