8. Tip the server upright.
9. Replace the left side panel, plug in the system power cord, and power on the
system
Cable Protector
Remove the cable protector before installing or removing a hard disk drive or
5.25-inch device.
Removing the Cable Protector
1. Power off the system and ensure it is disconnected from the AC power
source.
2. Remove the left side panel as described earlier in this chapter.
3. Slide the cable protector to the left, gently pull it toward you, and remove
the cable protector.
Installing the Cable Protector
1. Install the cable protector so that the cable protector is fully contained in the
server frame. The sponge backing on backside of the cable protector should
be positioned towards the top of the server next to the 5 ¼-inch device cage.
2. Tip the server upright.
3. Replace the left side panel, plug in the system power cord, and power on the
system.
4-18 Upgrading Your System
A
Figure 4-16. Installing an Option Board