Front View - NEC Express5800 User Manual

Getting Familiar with the System
Before setting up your system, you should become familiar with the system's
features, such as the location of your system's front and rear panel switches,
indicators and connectors, etc. Note that this section describes the tower-based
system controls (switches and indicators) and connectors, which are identical for
the rack-mount system.

Front View

Figure 2-1 shows the location of the front system features (tower-based system).
A
A. CD-ROM drive
B. 5.25-inch device
bays
C. POWER/SLEEP
lamp
D. Disk access lamp
E. POWER switch
F. 3.5-inch floppy
diskette drive
G. Stabilizer
2-4 Setting Up the System
G
Use this drive to read data from CD-ROM media.
Use these bays to mount optional devices such as a DAT (digital audio tape)
drive or magneto-optic disk drive.
Lights green when the power is turned on. Flashes while the server is
operating in power saving mode (sleep state) when the operating system
supports the power-saving feature.
Lights while the internal disk is in operation. This lamp does not indicate the
status of a device connected with an optional board (e.g., disk array board).
Press this switch to power the server ON or OFF. Pressing the switch once
lights the POWER/SLEEP lamp to indicate that the server is on. Pressing the
switch again turns the server OFF. To forcibly shut down the server, press the
switch for 4 seconds or more.
Use this drive to write/read data to/from a 3.5-inch floppy disk.
Stabilizes the server, preventing it from tipping over.
Figure 2-1. Front Features
B
C
D
E
F