Clearing Cmos - NEC Express5800 User Manual

Clearing CMOS

Clear CMOS as follows.
1. Power off the system and remove the left side panel as described in
Chapter 4 of this guide.
2. Check to ensure the system power cord is removed from the back of the
system.
3. Remove the spare jumper from position 11 - 12 on jumper block.
4. Reinstall the spare jumper on position 1 - 2 (CMOS Clear) of the jumper
block. Refer to Figure 3-1 and Table 3-1 to find the location of this jumper.
5. Connect the power cord, power on the system and after POST completes,
power down the system and unplug the power cord.
6. Remove the jumper from pins 1-2 and store the jumper on pins 11-12.
7. Replace the left side panel, connect the power cord and power on the
system.
8. Press
F2
Default Values" at the Exit menu.
at the prompt to run the BIOS Setup Utility, and select "Get
Configuring Your System 3-19