Standard Configuration
Your system is cabled using a dual channel on-board IDE Controller.
The on-board IDE controller supports two IDE hard disk drives on the primary IDE
channel and the standard internally mounted CD-ROM drive on the secondary IDE
channel. An additional IDE device may be connected to the secondary IDE channel.
A 3.5-inch diskette drive is also installed in all systems and interfaces separately to the
system board.
Figure A-1 illustrates the standard system configuration. The IDE interface cable (C) is
connected from the diskette drive IDE connector to the diskette drive (D). The primary
IDE interface cable (E) connects from the primary interface connector to the hard disk
drives (F). And the secondary IDE interface cable (G) connects from the secondary
interface connector to the rear of the internally mounted CD-ROM drive (H).
System Cabling A-3