Removing EMI Shields and Filler Panels
1. Power off the system and remove the front panel as described earlier in this
chapter.
2. The filler panels are attached to the front cover. Locate the filler panel
covering the bay into which you are installing a peripheral device. The filler
panel is released by pressing on its tabs located on the inside of the front
panel. Save the panel for reinstallation. See Figure 4-30.
3. Locate the EMI (Electromagnetic Interference) shield covering the bay into
which you are installing a peripheral device The EMI shield is attached to
the front of the chassis with two screws. Remove the screws and EMI shield
covering the bay into which you are installing a peripheral device. Save the
shield and screws for reinstallation. See Figure 4-31.
4-28 Upgrading Your System
Figure 4-30. Removing a Filler Panel
Figure 4-31. Removing an EMI Shield