Loading Tabbed Sheets In Tray 4 (Large Capacity Tray) - Oce 750 User Manual

Maintenance & Supplies
Loading Paper (continued)

Loading Tabbed Sheets in Tray 4 (Large Capacity Tray)

Load offset tabbed sheets so that the tab extensions are on the right at the rear (not
front) of the tray.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the
Key operator mode; otherwise mishandled paper may occur. See p. 8-16 to p. 8-17.
The top sheet is designated face up as the first tab of the finished set. Subsequent offset
tab sheets follow in sequence.
Rear
Front
Rear
Front
7-8 Maintenance & Supplies
Example (LT-401): 3 Tabbed sheets loaded in position for one finished set.
Section 1
Introduction
Printed
side
Example (LT-401): 9 Tabbed sheets loaded in position for 3 finished sets.
Section 1
Introducttion
Printed
side
1st TAB
Section 1
Introduction
2nd TAB
3rd TAB
ONE FINISHED SET
1st TAB
2nd TAB
1st TABS
2nd TABS
Section 1 Section 1
Introduction Introduction
3rd TABS
3rd TAB
3 FINISHED SETS
1st TAB
2nd TAB
3rd TAB
Section 1
Introduction