Loading Tabbed Sheets In Tray 1, 2, Or 3 - Oce 750 User Manual

Maintenance & Supplies
Loading Paper (continued)

Loading Tabbed Sheets in Tray 1, 2, or 3

Load offset tabbed sheets so that the tab extensions are on the left at the rear (not front)
of the tray.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the
Key operator mode; otherwise mishandled paper may occur. See p. 8-16 to p. 8-17.
The top sheet is designated face down as the first tab of the finished set. Subsequent
offset tab sheets follow in sequence.
Rear
Rear
7-6 Maintenance & Supplies
Example: 3 Tabbed sheets loaded in position for one finished set.
Front
1st TAB
2nd TAB
3rd TAB
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Section 3
Management
Front
1st TABS
2nd TABS
3rd TABS
Section 3
Management
Printed
Section 1
side Introduction
ONE FINISHED SET
1st TAB 2nd TAB
Section 1 Section 1
Introduction Introduction
Printed
side
3rd TAB
3 FINISHED SETS
1st TAB
2nd TAB
3rd TAB
Section 1
Introduction