Crossover Frequency - Sony STR-DN1070 User Manual

To output a test tone from adjacent speakers
See "Adjusting the balance between adjacent speakers by outputting a test tone (Phase
Noise)."
To output the source sound from adjacent speakers
See "Adjusting the balance between adjacent speakers by outputting a source sound (Phase
Audio)."
[153] Adjusting Settings Speaker Settings
Setting the crossover frequency of the speakers

(Crossover Frequency)

You can set the bass crossover frequency of speakers for which the speaker size has been set
to [Small] in the [Speaker Settings] menu. A measured speaker crossover frequency is set for
each speaker after the Auto Calibration is performed.
Select [Setup] - [Speaker Settings] from the home menu.
1
2 Select [Crossover Frequency].
Select the speaker for which you want to adjust the crossover frequency on the
3
screen.
Press / to set the crossover frequency.
4
Note
This function does not work in the following cases:
Headphones are connected.
[Bluetooth Mode] is set to [Transmitter].
[Size] for none of the speakers is set to [Small].
The surround back speakers will be set to the same setting as that of the surround speakers.
[154] Adjusting Settings Speaker Settings
Adjusting the equalizer (Equalizer)
You can use the following parameters to adjust the tonal quality (bass/treble level) of the front,
center, surround/surround back and front high speakers.
Level (dB)
Frequency (Hz)
Bass
Treble
Select [Setup] - [Speaker Settings] from the home menu.
1