Sony STR-DN1070 User Manual page 114

[162] Adjusting Settings Audio Settings
Enjoying more natural sound with speakers installed
in the ceiling (In-Ceiling Speaker Mode)
Set whether or not to use in-ceiling speaker mode with the current input.
In a setup where the front and center speakers are installed in the ceiling, lowering the audio
output position to the screen height allows you to enjoy a more natural experience.
Select [Setup] - [Audio Settings] from the home menu.
1
Select [In-Ceiling Speaker Mode].
2
Select [On].
3
Note
This function does not work in the following cases:
A speaker pattern with the front high speakers is selected.
Headphones are connected.
[Bluetooth Mode] is set to [Transmitter].
[Pure Direct] is set to [On].
The Wireless Multi Room function is activated.
[DSD Native] is set to [On] and a DSD file is played back.
This function does not work if you select a sound field other than the following:
2ch Stereo
Multi Ch Stereo
This function does not work when [Direct] is being used and analog input is selected.
This function may not work depending on the audio format.
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of
the input signals depending on the audio format.
Hint
You can also select [In-Ceiling Speaker Mode] in [Sound Effects] from the home menu.
To obtain the optimal sound for your listening environment, configure the [Ceiling Speaker Height]
setting in the [Speaker Settings] menu, then perform Auto Calibration.
[163] Adjusting Settings Audio Settings
Enabling the direct playback of DSD signals (DSD
Native)
You can set the receiver to process DSD (Direct Streaming Digital) signals directly without any
signal conversion and derive intrinsic sound quality of DSD signals.
Select [Setup] - [Audio Settings] from the home menu.
1
Select [DSD Native].
2
3 Select the setting you want.
On: This function is available for DSD signals.
Off: Does not activate the direct playback of DSD signals (DSD Native).