Sony STR-DN1070 User Manual page 104

[143] Adjusting Settings Performing Auto Calibration
Selecting the Auto Calibration type (Calibration Type)
You can select a calibration type after you have performed the Auto Calibration and saved the
settings.
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Calibration Type].
2
3 Select the setting you want.
Full Flat: Makes the measurement of frequency from each speaker flat.
Engineer: Sets to "the Sony listening room standard" frequency characteristics.
Front Reference: Adjusts the characteristics of all of the speakers to match the
characteristics of the front speaker.
Off
Note
This function does not work in the following cases:
Headphones are connected.
[Auto Calibration] has not been performed.
[Bluetooth Mode] is set to [Transmitter].
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of
the input signals, depending on the audio format.
[144] Adjusting Settings Speaker Settings
Selecting the speaker pattern (Speaker Pattern)
You can select the speaker pattern you want according to your speaker installation.
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Speaker Pattern].
2
Select the desired speaker pattern according to the speaker installation example
3
displayed on the TV screen, then select [Save].
Note
This function does not work in the following cases:
Headphones are connected.
[Bluetooth Mode] is set to [Transmitter].
If you select a speaker pattern with the speakers connected to the SPEAKERS SURROUND
BACK/BI-AMP/FRONT HIGH/FRONT B terminals and select [Save], [Zone2 Power] will be set to
[Off] automatically.