Sony STR-DN1070 User Manual page 116

Select the setting you want.
3
On: Always activates the low-pass filter with a cutoff frequency of 120 Hz.
Off: Does not activate the low-pass filter.
Note
This function does not work in the following cases:
[Bluetooth Mode] is set to [Transmitter].
[DSD Native] is set to [On] and a DSD file is played back.
[166] Adjusting Settings Audio Settings
Synchronizing audio with video output (A/V Sync)
You can delay the output of audio to minimize the time gap between audio output and a visual
display.
This function is useful when using a large LCD or plasma monitor or a projector. You can set
the function for each input independently.
Select [Setup] - [Audio Settings] from the home menu.
1
Select [A/V Sync].
2
Select the setting you want.
3
0 ms – 300 ms: You can adjust the delay from 0 ms to 300 ms in 10 ms intervals.
HDMI Auto: The time gap between the audio output and visual display of a monitor
connected via an HDMI connection will be adjusted automatically. This feature is
available only when the monitor supports the A/V Sync function.
Note
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of
the input signals, depending on the audio format.
This function is not available in the following cases:
[Bluetooth Mode] is set to [Transmitter].
[DSD Native] is set to [On] and a DSD file is played back.
[167] Adjusting Settings Audio Settings
Time-aligning the LFE (low frequency effect) channel
(LFE Time Alignment)
The LFE Time Alignment function allows you to shift the output timing of the LFE channel
forward for other channels. This function is effective for adjusting content in which there is a
gap between the LFE channel phase and other channel phases.
Select [Setup] - [Audio Settings] from the home menu.
1
2 Select [LFE Time Alignment].