Crossover Frequency - Sony STR-DA1800ES Operating Instructions Manual

To adjust the size of each
speaker
You can adjust each speaker's (front left/right,
front left/right high, center, surround left/right,
surround back left/right) size.
1
Select the speaker on the screen for
which you want to adjust the size, then
press .
2
Select "Size", then press
• Large: If you connect large speakers that
will effectively reproduce bass
frequencies, select "Large". Normally,
select "Large".
• Small: If the sound is distorted, or you
feel a lack of surround effects when using
multi channel surround sound, select
"Small" to activate the bass redirection
circuitry and output the bass frequencies
of each channel from the subwoofer or
other "Large" speakers.
Note
This function does not work when "A. DIRECT" is
being used.
Tips
• The "Large" and "Small" settings for each speaker
determine whether the internal sound processor
will cut the bass signal from that channel.
When the bass is cut from a channel, the bass
redirection circuitry sends the corresponding bass
frequencies to the subwoofer or other "Large"
speakers.
However, since bass sound has a certain amount of
directionality, it is best not to cut it, if possible.
Therefore, even when using small speakers, you
can set them to "Large" if you want to output the
bass frequencies from that speaker. On the other
hand, if you are using a large speaker, but prefer
not to have bass frequencies output from that
speaker, set it to "Small".
If the overall sound level is lower than you prefer,
set all speakers to "Large". If there is not enough
bass, you can use the equalizer to boost the bass
levels.
• The surround back speakers will be set to the same
setting as that of the surround speakers.
US
100
• When the front speakers are set to "Small", the
center, surround, and surround back/front high
speakers are also automatically set to "Small".
• If you do not use the subwoofer, the front speakers
are automatically set to "Large".
x Crossover Freq (Speaker
Lets you set the bass crossover frequency of
speakers that the speaker size has been set to
.
"Small" in the Speaker Settings menu.
Measured speaker crossover frequency is set
for each speaker after the Auto Calibration.
1
2
x Test Tone
Lets you select the test tone type on the "Test
Tone" screen.
Tips
• To adjust the level of all speakers at the same time,
press MASTER VOL +/–. You can also use
MASTER VOLUME on the receiver.
• The adjusted value is shown on the TV screen
during adjustment.
To output test tone from each
speaker
You can output test tone from the speakers in
sequence.
1
2
3

crossover frequency)

Select the speaker on the screen for
which you want to adjust the crossover
frequency, then press
Adjust the value, then press
Select "Test Tone", then press
Adjust the parameter, then press
• OFF
• AUTO: The test tone is output from each
speaker in sequence.
• FL, CNT, FR, SR, SB*, SBR, SBL, SL,
LH, RH, SW: You can select which
speakers will output the test tone.
* "SB" appears when only one surround back
speaker is connected.
Adjust the speaker level, then press
.
.
.
or b.
.