Customer Support Websites - Sony STR-DN1070 User Manual

Point the remote control at the remote control sensor on the receiver.
Remove any obstructions between the remote control and the receiver.
Replace both of the batteries in the remote control with new ones if they are weak.
[292] Troubleshooting If the problem is not solved
Reverting to the factory default settings
You can clear all memorized settings and restore the receiver to the factory default settings by
the following procedure. This procedure can also be used to initialize the receiver before you
use it for the first time.
Be sure to use the buttons on the receiver to perform this operation.
1 Turn off the receiver.
Hold down (power) on the receiver for 5 seconds.
2
[CLEARING] flashes on the display panel for a while, then changes to [CLEARED !].
Note
It takes a few minutes for the memory to be cleared completely. Do not turn the receiver off until
[CLEARED !] appears on the display panel.
[293] Troubleshooting If the problem is not solved
Resetting sound fields to the default settings
Be sure to use the buttons on the receiver to perform this operation.
Turn off the receiver.
1
Hold down MUSIC and press
2
[S.F. CLEAR] appears on the display panel and all sound fields are reset to their default
setting.
[294] Troubleshooting If the problem is not solved

Customer support websites

Refer to the following websites for the latest information on the receiver.
For customers in the USA:
http://esupport.sony.com/
For customers in Canada:
http://esupport.sony.com/CA/
For customers in Europe:
www.sony.eu/support
For customers in Asia-Pacific countries and regions:
http://www.sony-asia.com/support
(power) on the receiver.