Enabling film mode detect
Enables or disables the detection of film motion.
1. Select MENU > Image Settings > Advanced Image Settings > Film Mode Detect.
2. To enable the detection of film motion, select Auto Detect.
3. To disable the detection of film motion, select Disabled.
4. Select Enter.
Adjusting the image sharpness
Change the sharpness of the image.
Lower settings can improve a noisy signal. Setting the sharpness above the halfway point can
introduce noise in the image.
1. Select MENU > Image Settings > Advanced Image Settings > Sharpness.
2. Select Enter.
3. Use the right and left arrows to adjust the sharpness of the image.
4. To confirm your selection, select Enter.
Enabling edge blending
Combine several projected images into one single, seamless image with edge blending.
1. Start with two projectors and display the full white field test pattern from both.
2. On one projector, select MENU > Configuration > Edge Blending.
3. To enable edge blending, select Basic.
4. Select Basic Edge Blending and select Enter.
5. From the Basic Blending dialog, select a side to blend.
6. To make the blending adjustments, use the arrow keys to change either the vertical and
horizontal values as appropriate.
7. To accept the selection, select Enter.
8. Repeat steps 4 to 6 to blend the remaining sides.
9. When all adjustments are made, use the arrow keys to highlight Apply Changes and select
Enter.
10. Repeat steps 2 to 9 for the remaining projectors.
11. To turn off edge blending, from MENU > Configuration > Edge Blending, select Off.
Boxer 30 (Bb.2) User Manual
020-102016-02 Rev. 1 (02-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Adjusting the image
22