2. Select the adjustment most suited to the input signal:
•
Auto Detect—Automatically detect the appropriate color correction mode, where possible.
•
Max Drives—All color adjustments are turned off, allowing the projector to run at
maximum brightness.
•
Color Temperature—Specify a color temperature between 3200 and 9300, expressed in
degrees Kelvin.
•
HD Video—Set the output color to a specific standard value. Adjusts the colors red,
green, blue, and white.
•
DCI P3—Set the DCI P3 (cinema) colorimetry with DCI white point.
•
DCI P3 (D65)—Set the DCI P3 colorimetry with D65 white point.
•
Custom—Select a user defined set of color adjustments.
3. Select Enter.
Correcting for ambient light
Ambient light is the natural light that occurs in the environment where the projector is located.
1. Select MENU > Image Settings > Color & Gamma > Ambient Light Correction.
2. Select Enter.
3. Use the right and left arrows to adjust how the image displays in conditions with ambient light.
4. To confirm your selection, select Enter.
Setting the frame delay
Delay the output signal timing relative to the input signal timing by a fraction of a frame, and up to
several frames.
The minimum latency can vary based on the amount of scaling applied to the image. When using
keystone or warping, an additional latency is required, depending on the amount of warp.
1. Select MENU > Image Settings > Advanced Image Settings > Frame Delay.
2. To set the frame delay, select Set Delay.
3. Adjust the value and to confirm your selection, select Enter.
4. To set the achievable frame delay, select Actual Delay.
5. Adjust the value and to confirm your selection, select Enter.
Enabling film mode detect
Enables or disables the detection of film motion.
1. Select MENU > Image Settings > Advanced Image Settings > Film Mode Detect.
2. To enable the detection of film motion, select Auto Detect.
3. To disable the detection of film motion, select Disabled.
4. Select Enter.
4K40-RGB User Guide–D4K40-RGB, Roadie 4K40-RGB
020-102958-05 Rev. 1 (04-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Adjusting the image
27