Slot Cover - Sony PXW-X320 Operating Instructions Manual

Left side and upper section
a ASSIGNABLE 4/5 switches
You can assign the desired function to this switch
on "OPERATION" > "Assignable SW" in the
setup menu (see page 165).
Off is assigned to these switches when the
camcorder is shipped from the factory.
b Dedicated wireless adapter connector
Remove the cover to attach a CBK-WA101
Wireless Adapter (not supplied). For details about
attaching the CBK-WA101, refer to the
Operating Instructions or Installation Manual of
the CBK-WA101.
c PC connector
Used to put this camcorder into USB connection
mode and use it as an external storage device for
a computer. When a computer without
ExpressCard slot is connected to this connector,
every memory card inserted in the camcorder is
recognized as a drive for that computer.
d External device connector
Connect an optional CBK-WA101 Wireless
Adapter, IFU-WLM3 USB Wireless LAN
Module, or USB flash drive.
When connecting the CBK-WA101 or IFU-
WLM3: You can connect the camcorder and
device via wireless LAN connection.
When connecting a USB flash drive: You can
record, store, or load the following data.
• Planning metadata (see page 97)
• Setting data file (see page 170)
Note
Use this connector only for connecting the
CBK-WA101, IFU-WLM3, USB flash drive, or USB
media. Do not connect and use a USB hub or similar
products.
For details about wireless LAN connection, see
"Connecting the Camcorder to Devices using the
IFU-WLM3 USB Wireless LAN Module" (page 81)
or "Connecting the Camcorder to Devices using the
CBK-WA101 Wireless Adapter" (page 85).
e SxS memory card slots
These two slots (A and B) can receive SxS
memory cards or other recording media (see
page 63).
f ACCESS lamps
Indicate the state of slots A and B (see page 63).
You can check whether the lamps are lit even
when the slot cover is closed.
g EJECT (SxS memory card eject)
buttons (see page 63)
h Slot cover
Slide to the left and right to open and close.
18