Monochrome Lcd Panel - Sony PXW-X320 Operating Instructions Manual

b TALLY switch
Set to ON to activate the TALLY indicator
function.
c EARPHONE jack (stereo, minijack)
You can monitor the E-E sound during recording
and playback sound during playback. When an
alarm is indicated, you can hear the alarm sound
through the earphone. Plugging an earphone into
the jack automatically cuts off the built-in
speaker.
You can select monaural or stereo on
"MAINTENANCE" > "Audio" in the setup
menu.
d AUDIO IN selector switches
Select the audio source you connect to the
AUDIO IN CH-1/CH-2 connectors.
LINE: When connecting a stereo amplifier or
other external audio signal source
MIC: When connecting a microphone that does
not require 48 V power supply
+48V: When connecting a microphone that
requires 48 V power supply
e HD/SD SDI OUT connectors (BNC
type)
The camcorder has two HD/SD SDI OUT
connectors.
These connectors output an HDSDI or SDSDI
signal (with embedded audio). The output from
these connectors can be turned on or off, on
"OPERATION" > "Input/Output" > "SDI
Output" in the setup menu.
f AUDIO IN CH-1/CH-2 (audio channel
1 and channel 2 input) connectors (XLR
type, 3-pin, female)
You can connect audio equipment or a
microphone.
g Bottom cover
This is provided for protecting the cables
connected to the connectors on the rear panel.
By loosening the screws which retain the cover to
the bottom of the camcorder, you can adjust the
position of the cover depending on the size and
shape of the microphone or audio cable plugs.
After adjusting the position, tighten the screws to
secure the cover.
h AUDIO OUT connector (XLR type,
5-pin, male)
Outputs the audio signals recorded on audio
channels 1 and 2 or audio channels 3 and 4.
The audio signals are selected by the MONITOR
switch.
i REMOTE connector (8-pin)
Note
Before connecting/disconnecting the Remote Control
Unit to/from the camcorder, be sure to turn off the
camcorder POWER switch.
j i.LINK (HDV/DV) connector (6-pin,
IEEE1394 compliant, S400)
To input and output HDV/DV streams, connect to
an HDV/DV device.

Monochrome LCD Panel

a Timecode status indicator
NDF: Appears when non-drop-frame timecode is
selected.
EXT-LK: Appears when the internal timecode
generator is locked to an external signal input
to the TC IN (timecode input) connector.
b Counter display mode
Shows the type of information selected by the
DISPLAY switch to be displayed in the time
counter display.
COUNTER: Counter values
TC: Timecode
U-BIT: User bits data
c Time counter display
Switches displays of time counter values,
timecode, and user bits data, depending on the
position of the DISPLAY switch.
20