Defining Clip Names In Planning Metadata - Sony PXW-X320 Operating Instructions Manual

metadata file into the camcorder's memory before
starting to shoot.
There are two ways to load files.
• Load a file that has been written to the following
directories on an SxS memory card or a USB
flash drive.
Recording Media
mode
FAT SxS memory
card
SDHC
exFAT SxS memory
card
USB flash drive General/Sony/
UDF SxS memory
card
USB flash drive
• When a wireless LAN connection is made
between the camcorder and a device, operate
the Web menu built in the camcorder from the
device to transfer a file.
To load a planning metadata file by menu
operation
Do the following procedures with
"OPERATION" > "Planning Metadata" in the
setup menu.
To load a file in an SxS memory card
1
Insert an SxS memory card into the
memory card slot A or B, and set
"Load/Slot(A)" or "Load/Slot(B)" to
"Execute."
A file list appears.
Note
The file list displays up to 64 files. Even if the total
number of planning metadata files is 64 or less, all
of the planning metadata files may not appear if the
directory where they are located on the SxS
memory card (General/Sony/Planning) contains
512 or more files.
2
Turn the MENU knob to select a file to
load and press the knob.
Directory to
which files are
written
BPAV/General/
Sony/Planning
PRIVATE/SONY/
BPAV/General/
Sony/Planning
XDROOT/
General/Sony/
Planning
Planning
General/Sony/
Planning
98
To load a file in a USB flash drive (UDF, exFAT
modes)
1
Connect a USB flash drive formatted
with the FAT32 file system to the
external device connector (see page 68).
A file list appears.
Note
The file list displays up to 64 files. Even if the total
number of planning metadata files is 64 or less, all
of the planning metadata files may not appear if the
directory where they are located on the USB flash
driver (General/Sony/Planning) contains 512 or
more files.
2
Turn the MENU knob to select a file to
load and press the knob.
To display detailed information in
planning metadata
After loading planning metadata into the
camcorder, you can check the detailed
information that it contains, such as file names,
date and time of creation, and titles.
Select "OPERATION" > "Plan.Metadata" >
"Properties" (see page 136) in the setup menu,
then select "Execute."
To clear the planning metadata loaded
Select "OPERATION" > "Plan.Metadata" >
"Clear" (see page 136) in the setup menu, then
select "Execute."
Defining Clip Names in Planning
Metadata
The following two types of clip name strings can
be written in a planning metadata file.
• The ASCII format name that appears in the
viewfinder
• The UTF-8 format name that is actually
registered as the clip name
Select "OPERATION" > "Plan.Metadata" >
"Clip Name Disp" (see page 136) in the setup
menu, then select which type of clip name is
displayed.
When a clip name is set with planning metadata,
the name is displayed under the depth of field
indication on the viewfinder screen.