Fuel Tank Installation - AeroWorks Carbon Cub SS ARF-QB Assembly Manual

9. Secure the rubber stopper with set screw. Take
care not to strip threads by over tightening set
screw.

Fuel Tank Installation

1. Gather the fuel tank parts as shown below. Fuel
tank, fuel tubing, foam rubber, fuel "T", fuel
filler dot and nylon ties.
Note: The fuel "T", and fuel line are not supplied,
but are available through Aeroworks.
2. Install a short piece of fuel line and the fuel "T"
to the fuel pick up tube.
Note: Using a heat gun to soften the fuel line will
help with the installation of the fuel "T".
3. Install the fuel pick up and fuel filler lines to the
fuel tank.
Note: It is recommended you always use a fuel
filter on your gas can, filters should not be
installed inside the airplane. Inline fuel filter
can clog and cause your engine to quite.
Vent
Line
67
T
Line
Carb
Fill