Throttle/Choke Installation - AeroWorks Carbon Cub SS ARF-QB Assembly Manual

1. Gather the throttle and choke items as shown
below:
Required Parts
◊
2 - Prebuilt Plywood Servo Mounts
◊
2 - 4-40x300mm Threaded Pushrods
◊
2 - 4-40 Threaded Solder Couplers
◊
4 - 4-40 Ball Links
◊
4 - 4-40x16mm Hex Head Bolts
◊
4 - 4-40 Lock Nuts
◊
4 - Brass Spacers
◊
4 - 3mm Flat Washers
Required Parts -Not Included
◊
1 - Throttle Servo
◊
1 - Choke Servo (Optional)
◊
8 - Servo Mounting Screws (Micro Fastener
Part number STW0209 recommended)
◊
2 - 3/4" servo arms
Required Tools and Adhesives
◊
1 - Pencil/felt tip pen
◊
1 - Phillips Screw Driver
◊
1 - 5/64" Ball Driver
◊
1 - Electric Drill
◊
1 - 1/16" Drill Bit
◊
1 - Rotary Cutting tool with Cutting Disk
◊
1 - Wire Cutter
◊
1 - Soldering Iron
◊
1 - Silver Solder "Sta-Brite Recommended"
◊
1 - 80 Grit Sandpaper
◊
1 - .34oz Bottle Blue IC-Loc Thread Locker
Throttle Servo and Choke Installation
2. Use a Felt tip pen or a pencil to mark the loca-
tion of the throttle servo onto the bottom of the
motor box.
Note: If using canisters, temporarily install the
headers at this time. The throttle servo should
sit between the two headers.
3. Use a rotary cutting tool with a cutting disk to
remove the section of the motor box floor as
marked in step 2.
Note: Cover the carburetor inlet as well as the
exhaust opening while cutting. This will
prevent any sawdust from entering the engine.
57