Canister Installation
1.
Gather the canister muffler parts as shown:
Required Parts
◊
2 - Canister Mounting Bracket w/ Silicone
Tubing (Flex or Non-Flex)
Required Parts -Not Included
◊
2 - MTW TD 75H Rear Exit Canisters
◊
2 - 70mm Drop Flex Headers
◊
2 - 3" Teflon Couplers
◊
2 - Header Gaskets
◊
4 - Header Clamps
◊
4 - Header Mounting Bolts
◊
2 - 6" Silicon Stinger Extensions
Required Tools and Adhesives
◊
1 - 9/64" Ball Driver
◊
1 - .34oz Bottle Blue IC-Loc Thread Locker
2.
Using a covering iron seal the covering around
the air exit holes at fuse bottom as shown be-
low.
CANISTER INSTALLATION
76
3. Use a hobby knife to remove the covering
around the hot air exit holes.
4.
Remove the (8) Phillips head screws holding the
canister hatches in place.