Fiat 1996 Brava Service Manual page 776

Bravo-Brava
9 8 range
Electrical equipment
Radio equipment
55.
Connections
This paragraph contains the connect at the rear of the radio equipment.
c-
B-
J ft A
^
^
3 6
2 5
Li-i *| <| | |
L^
I I
I I I I
-T5A
Supply voltages
Blade contacts A:
A8 Connection for earth
Connect to terminal 31 (earth) of the vehicle.
A7 Connection for 1 2 V supply voltage
Connect to terminal 30 (continuous positive)
of the vehicle.
A6 Connection for instrument light
Contact not connected: no light with the ra­
dio switched off if the instrument light is on.
A5 Output switching voltage of +12 V
(max 0.5 A)
Present at A 5 blade contact when the radio is
on.
For automatic aerial (extended/retracted),
aerial amplifier (supply voltage).
Speakers
Blade contacts B
Maximum power at speakers 4 : 4 x 2 0 W or 2 x 15 W
Connection for 4 x 20 W
Front speaker: Rear speaker:
B3 right + B1 right +
B4 right - B2 right -
B5 left + B7 left +
B6 left - B8 left -
Connection for 2 x 1 5 W
B3 right +
B2 right -
B5 left +
B8 left -
When operating with 2 x 15 W the FADER should be switched off in the EXPERT Menu
A4 Connection for voltage of +12 V
Connect to terminal 15 of the vehicle if the
radio is going to be switched on and off via
the ignition.
Connection A 4 may also be not wired. In this
case, the radio should come on and off via
the V O L c o n t r o l .
With the engine switched off, the equipment
is switched off about 20 minutes later
A2 Phone-Mute connection for car phone
or receiver-transmitter
The radio audio function is deactivated dur­
ing the operation of the car phone or the re­
ceiver-transmitter.
The message "PHONE" appears on the dis­
play.
Contact A 2 should be earthed from the mute
outlet of the telephone/receiver-transmitter!
Copyright by Fiat Auto
XI-98 Upd|p 77