Bravo-Brava A i
16v
Auto transmission and differential
Servicing and adjustments
21-27.
P4A47AB03
P4A47AB02
Refitting
Refit the selector lever position sensor as fol
lows:
1. position the sensor, tighten the central nut
and lock it with the washer;
2. from position P (fully rotated in a clock
wise direction) move the pin of the lever
to position N (rotating the pin two notch
es in an anti-clockwise direction);
3. rotate the sensor so that the projection on
the top surface (1) lines up with the side
machining on the pin (2), then lock the
sensor in this position by tightening the
two side screws.
It is advisable to position the sensor
using an ohmmeter connected be
tween terminals 6 and 10 of the sup
ply connector. Rotate the sensor to
the centre of the area in which the
ohmmeter detects continuity
(con
tacts N and P closed), then tighten
the sensor screws.
Copyright Fiat Auto
4 7