Fiat 1996 Brava Service Manual page 304

Bravo- Brava |p> ^
'98 range
Engine
Fuel system
10.
Removing-refitting
Disconnect the accelerator cable as follows:
- working from inside the vehicle (A), discon­
nect the control cable from its anchorage on
accelerator pedal (B);
- turn the accelerator lever to disengage the
accelerator cable terminal from lever (C).
Then remove the adjustment block from
bracket (D) and move the accelerator cable
aside.
Reverse removal instructions to refit.
ENGINE IDLE A D J U S T M E N T ACTUA­
TOR/THROTTLE POSITION SENSOR
NOTE The engine idle adjustment actua­
tor/throttle position sensor should be
disconnected from the throttle body
only in case of rep/acement_because
removing/refitting causes damage to
certain components (e.g. internal
sealing rings) and correct component
operation cannot be guaranteed once
the component is refitted.
Removing-refitting
To remove the actuator, disconnect the con­
nector and unscrew the retaining bolts (ar­
rowed).
NOTE It is compulsory to zero and self-learn
engine idle adjustment actuator
(M.D.S) data as described in the
"THROTTLE BODY" paragraph.
Copyright Fiat Auto
V-99 Cancisls <jnd replaces
53