Installing The Spinner - Seagull Models Extra 300S Assembly Manual

3) Install the muffler and muffler extension
onto the engine and make the cut out in the
cowl for muffler clearance. Connect the fuel
and pressure lines to the carburetor, muffler
and fuel filler valve. Secure the cowl to fuse-
lage using the 3x10mm screws (4).

INSTALLING THE SPINNER.

Install the spinner backplate, propeller and
spinner cone.
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
www.seagullmodels.com
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
vided with your radio system.
INSTALLING THE FUSELAGE SERVO.
Because the size of servos differ, you
1) Install the rubber grommets and brass
2) Secure the servos with the screws pro-
Throttle servo.
Rudder
servo.
Elevator servo.
Elevator servo.
9