How To Enter Ship Speed - Furuno FMD-3200 Operator's Manual

1. INTRODUCTION
1.10

How to Enter Ship Speed

The speed can be entered from a log (STW) or GPS (SOG), or manually on the menu.
Note that FURUNO GPS Navigator GP-150 provides both COG and SOG.
Speed data is checked for integrity (see section 18.7 for details), and the data is
judged as [Doubtful], [Excluded], [Failed], [Not Available], or [Passed]. The results of
the check appear on the [SPD] page, shown below. (The results do not appear when
the TCS is engaged.)
[Doubtful] (yellow): Data is not available for comparison, but data is normal.
[Excluded] (red): Data value changed significantly.
[Failed] (red): Data may or may not be available for comparison, and data is abnor-
mal.
[Not Available] (red): Sensor malfunction or data is improper.
[Passed] (green): Data is available for comparison and data is normal.
1. Right-click anywhere in the [Own ship information] box to show the context-sensi-
tive menu.
2. Click [Open MENU].
3. Click [System Sensor Settings] or [Local System Settings] as applicable.
4. Click the [SPD] tab.
Stablilization
mode
LOG/GPS
selection
1-10
Open MENU
Fill circle for automatic speed input
Speed sensor list
Set course and speed of drift
Check to use radar as source for speed and course
Fill circle for manual speed input
SPD page, local sensor
PRIM: MAN/WTC
SPD:
Integrity: Passed
Integrity
check
result