Own Ship Functions Box - Furuno FMD-3200 Operator's Manual

2. OPERATIONAL OVERVIEW
2.1.5

Own ship functions box

The own ship functions box shows information about own ship, enables offset, and does
TM reset.
Offset button
WGS84 button
RNC info
appears here.
• [Offset] button: See section 18.8.1. This button is only operative in the Voyage navi-
gation mode.
• [WGS84] button: Convert position data between
datum; go to selected position on the current
chart. Click the button to show the dialog box be-
low. To convert a position from one datum to an-
other, select the datum source at the [Source] pull-
down list and enter position. Select the datum to
convert to at the [Converted] pull-down list then
click the
ed is shown below the [Converted] pull-down list.
To go to a position, click a [Go To] button.
• ENC info: ENC chart info appears here.
No indication: ENC chart is currently displayed.
"ENC data available": Currently, RNC chart is
shown, but ENC chart is available.
"Non-ENC data": Non-official ENC material, in yel-
low characters. See section 3.20.
• RNC info: "RNC data" appears (in yellow) when raster chart is in use.
• TM/CU status:
"TM/CU Reset": True motion reset is active. (Chart is stationary and own ship moves
on the chart.)
"TM Reset off": When dragging the chart; true motion is OFF. To restart true motion,
click the indication,
"Ship off screen": Ship is out of the display area.
2-10
button. The position on the chart select-
ENC info
appears here.
TM/CU status